Zepro ZHDN 2500-150, Руководство по установке

Страница: 15 / 58

ZHDN 2500-150 Installation
15 www.zepro.com
700 245 245
A max
6 Installation
Consult the trailer manufacturer’s body instructions and Zepro’s instruction booklet before
installation.
NOTE.
Zepro tail lifts are only approved for installation with Zepro installation kits.
m
WARNING!
6.1 Chassis brackets
1. Place the chassis brackets on the support frame.
2. Adjust the distance between the brackets according to the chassis width and centre the frame so
that the distance from the end of the frame to the bracket is the same on the left and the right.
3. Attach the clamp on the rear of the chassis bracket using the supplied washers and nuts.
4. Tighten the bolts using a torque wrench.
Tightening torque: 260 Nm.
Image 12. Fitting the chassis bracket
6.2 Rear beam cut outs
It is often necessary to create cut outs in the rear beam to provide space for the platform arms
when the platform is in the upper position. The size of the cut outs depends on the calculated
installed dimension “A”, see illustration below.
1. Measure and mark the location and depth of the cut outs on the rear beam. The two cut outs
must be centred on the rear beam, i.e. both cut outs must be an equal distance from the mid-
point of the beam.
2. Cut along the markings.
3. Grind away any burr or sharp edges.
Image 13. Rear beam cut outs