Z70 v2
60
Ringtone Volume
[
disabled/
enabled
]: enables the box to modify the calls tone volume.
SIP ID/IP Address/Gateway
[
disabled/
enabled
]: information box showing the ID, IP
address and gateway
, as configured in “IP Configuration” tab (see section 0)
“Do Not Disturb” Mode: Enabling
[
disabled/
enabled
]: checkbox to enable or disable
the do not disturb mode. When enabled, incoming calls will not be received. However, in
case of Video Intercom functionality, they will be registered in the call log.
When enabling the mode, the value ‘1’ is sent through the object “
[VoIP] “Do Not
Disturb” Mode
” and when disabling it is sent the value ‘0’.
Note:
If do not disturb mode is enabled during a call, the call will go through normally
and the mode will be activated when the call finishes.
“Do Not Disturb” Mode: Timing
[
disabled/
enabled
]: this box set the time that the do
not disturb mode will be active. A time 0 will activate this mode indefinitely.
When enabling the mode, the value ‘1’ is sent through the object “
[VoIP] “Do Not
Disturb” Mode
” and when the timing expires it is sent the value ‘0’. It is also possible to
stop the countdown disabling the mode (by manually or through the communication
object).
2.2.1.3
PAGE
N
Z70 v2 has up to twelve general purpose pages that can be enabled from the "Pages" tab. Thus,
a new tab called
Page n
will be displayed for each of the
n
enabled pages.
Inside each page, the desired controls can be placed as boxes arranged in order, according to
the parameters for each page. In addition, larger boxes can be created by grouping 4 boxes,
with a format of 2x2. To make this type of grouping it is necessary to configure the page as
shown in Figure 47.
Figure 47.
2x2 Boxes Configuration
