Z70 v2
44
Time to Exit Cleaning Status
[
5...
15
…65535
][
s
] [
1…65535
][
min/h
]: timeout to
deactivate the cleaning function after triggered.
Message Notification
[
Cleaning…
]: textbox to enter the desired message.
Notify Expiration
[
No
/ Blink Message / Play Sound / Both
]: sets whether to notify the
timeout expiration or not. When any of the three later options is selected, a new
parameter shows up:
➢
Length of the Warning
[
1...
5
…65535
][
s
] [
1…65535
][
min/h
]: sets the ahead-time
to start the notification prior to the end of the cleaning function.
The “
[General] Cleaning Function
” one-bit object triggers the cleaning function when it
r
eceives a “1” from the KNX bus.
2.1.12.2
POP-UPS
This function permits showing the user a
pop-up message
of up to four lines of text on the
display, each of which can be object-dependant or set in parameters.
It is possible to enable up to 6 pop-ups, each of which can be launched in 3 different ways: by
using a 1-bit object, by using a 1-byte object or by modifying the text of one of the messages.
They can also be launched when activating the different states of the control of Room State (see
section 2.2.2.1.2.6).
The pop-up can be closed pressing the confirmation button inside it or using the 1-bit or 1-byte
objects named above.
Figure 28.
Pop-up
