Z70 v2
34
Default Ring Volume (after Programming)
[
No sound / 1 / 2 /
3
/ 4 / 5
]: define the VoIP
calls volume after Programming.
Synchronize with other Devices in the Same Network
[
disabled/
enabled
]: enables
the device to share the call status and history with all other units connected to the same
network that have this functionality enabled. Then the following parameter will also
appear:
➢
Synchronization Password
: field that must match in all the devices to
synchronise.
Note: Synchronisation with other devices is only available for Z70 v2. If there is a Z41
COM in a system, synchronisation will not be performed.
In addition, when the parameters
Video Intercom
and/or
Internal Calls
are enabled, the
following objects will appear:
“[VoIP] “Do Not Disturb” Mode”
: 1-bit object that enables and disables the do not
disturb mode of the Z70 v2 VoIP functionality. While this mode is active, Z70 v2 will not
receive any incoming calls, but the calls will be recorded in the log.
“[VoIP] Video Intercom Ringtone”
or
“[VoIP] Internal Call Ringtone”
: 1-byte object
to change the video intercom or internal call ringtone.
“[VoIP] Ringtone Volume”
: object to change the volume of the incomming calls
ringtone.
“[VoIP] Active Call”
: this object is sent to the bus
(with value ‘1’) when a call starts and
(with value ‘0’) ends, indicating whether the call is active or not. The purpose of this
object is, for example, to be able to mute a stereo during a call and have the sound
resumed at the end of the call.
“[VoIP] Play Video Intercom Ringtone”
: 1-bit object that plays the video intercom
ringtone once.
2.1.11.1
VIDEO INTERCOM (LICENSE REQUIRED)
Note: Video Intercom functionality requires a license installation. If not, even being possible to
configure it from ETS, its use will not be accessible.
