ZENN
iO
AVANCE
Y
TECNOLOGÍA
www.zennio.com
38
DIMMER CONTROL
This function results on sending a (4 bits) Dimming Control Object to
the BUS.
Dimming is typically quantified using percentages, such as 10%
dimming, and usually refers to the reduction in measured lumen output.
Therefore, a 100-lumen light source in a 10% dimmed system would
produce 10 lumens.
RESPONSE
Æ
Depending on the chosen option, the Control Object
may be:
Light ON
: Turn the light ON. “The BUS receives a “1”.
Light OFF
: Turn the light OFF. “The BUS receives a “0”.
Light ON/OFF
(toggle): Alternative switching between the
ON/OFF orders (to manage the lighting level with an only input).
Increase Light
: Every press on the screen increases the lighting
level, this parameter depends on the “Dimming Step” set, (See
below).
A short press reduces the lighting level; a second press stops the
“Increase”.
Reduce Light
: Reduces the lighting level with every press on the
screen, this parameter depends on the “Dimming Step” set, (See
below).
A short press reduces the lighting level; a second press stops the
“Reduction”.
Increase/Reduce Light Switching
: Alternative Switching between
the orders Increase and Reduce Light level.
DIMMING STEP
Æ
Depending on the value selected, different
lighting levels are offered. Once selected the “DIMMER CONTROL”
option, it is necessary to set this parameter.
Dimming Step
Necessary pulsations for a
complete regulation (0 – 100%)
6. 100%
1
5. 50%
2
4. 25%
4
3. 12.5%
8
2. 6.25%
16
