DALIBOX Broadcast 6CH/4CH
http://www.zennio.com
Soporte técnico:
http://support.zennio.com
12
Channel ‘x’
: checkboxes to enable or disable the required output channels.
Manual Control
: options are “Disabled”, “Only Test Off Mode”, “Only Test On
Mode” and “Test Off Mode + Test On Mode” (default). Depending on the
selection, the device will permit using the manual control under the Test Off,
the Test On, or both modes. Note that, as stated before, using the Test Off
mode does not require any special action, while switching to the Test On
mode does require long-pressing the Prog./Test button.
Manual Control Lock
: unless the above parameter has been disabled,
the Lock Manual Control parameter provides an optional procedure for
locking the manual control in runtime. When this checkbox is enabled,
object “
Manual Control Lock
” turns visible, as well as two more
parameters:
•
Value
: defines whether the manual control lock/unlock should take
place respectively upon the reception (through the aforementioned
object) of values “0” and “1”, or the opposite.
•
Initialization
: sets how the lock state of the manual control should
remain after the device start-up (after an ETS download or a bus power
failure): “Unlocked”, “Locked” or “Last Value” (default; on the very first
start-up, this will be Unlocked).
Power Supply Error Object
: enables/disables a one-bit object (“Error: Power
Supply”) that will notify (by sending the value “1” periodically) the existence of
a power supply failure. See section 2.2.5. Once the error is over, it will send
the value “0” (once).
