26
CONFIDENTIAL
DOC-USR-0146-02
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
5.15
Running DHCP
DHCP is also supported. When enabled, the single board encoder dynamically receives an IP address to
use at startup. To see how DHCP support works, you can do the following steps:
The first thing you need to do is set up a custom configuration and save this so that the DHCP setting
is used the next time the system boots up. To do this, click on the “User Presets” tab and click on
“new”:
This brings up a new text box to enter the preset name. Type “z3_test” and click “ok”:
Return to the System Setup tab. Go to the bottom of the screen and select the “z3_test” preset that
you just created. The system might take a few moments to reload values.
Figure 23 The User Presets Tab
Figure 24 Entering a User Preset Name
Figure 25 Setting “z3_test” as the preset configuration
(1) Click here to select “User Presets”
(2) Click here to set a new preset
Select “z3_test”
