45
CONFIDENTIAL
DOC-USR-0146-02
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
Aux TS File Enable
(UDP Only)
True
False
For UDP streaming only. If UDP is being streamed,
this allows the same UDP stream to be saved to a
TS file. The name of the file is specified in “Aux TS
File Location.”
Aux TS File Location
(UDP Only)
/tmp/aux1.ts
Appears if “Aux TS File Enable” is set to “True.”
Specifies where to save the TS file. For example,
if a USB drive is connected, the value
“/media/sda1/example.ts” could be specified.
Video PID (UDP Only) 0 – 8191 (
220
)
PID assigned to video in the TS stream.
PCR PID (UDP Only)
0 – 8191 (
520
)
PID assigned to PCR in the TS stream.
PMT PID (UDP Only)
0 – 8191 (
31
)
PID assigned to PMT in the TS stream.
TS Rate (UDP Only)
125K – 20000K (
8000K
)
The rate of the transport stream. Normally, this
value should be set to 1.25 * (video b audio
bitrate). This can be set to higher values to allow
leeway for times when many bits are needed to
encode. This can be especially useful for ensuring
smooth playback at lower bitrates (see Section
Error! Reference source not found.
).
TS Lowlat Mode (UDP
Only)
True
False
Normally the TS muxer gathers data into packets
of maximum network size. While this leads to
maximum network efficiency, it can lead to
increases in latency. Turning “Lowlat Mode” on
causes the TS muxer to instead send packets out as
soon as it receives them. This results in lower
latency at the expense of decreased network
efficiency and a less smooth bitstream. TS Lowlat
Mode has a limit of 5Mbps.
Authentication
(RTMP only)
Disable
Enable
When in RTMP mode, the SME-01 supports entering
an authentication User name and Password. If this
is desired, set Authentication to “Enable”. A
“User” and “Password” text box then becomes
active. The user then enters the appropriate User
name and Password.
