User Guide for the CP860 IP Conference Phone
60
You can press the on-hook key either before or after entering the number to place a call.
You can also dial an entry from call history, local directory or remote phone book. For
more information, refer to
Contact Management
on page
31
and
Call History
Management
on page
44
.
The call duration of the active call is visible on the LCD screen. In the figure below, the
call to Jim has lasted 6 seconds.
To place a call:
Do one of the following:
-
Press to obtain a dial tone.
Enter the desired number using the keypad.
Press , , or the Send soft key.
-
Enter the desired number using the keypad.
Press , , or the Send soft key.
The # key is configured as a send key by default. You can also set the * key as the send
key, or set neither. For more information, refer to the
Key as Send
on page
25
.
Note
The CP860 IP conference phone can handle multiple calls at a time. However, only one
active call (the call that has audio associated with it) can be in progress at any given
time.
To place multiple calls:
You can have more than one call on your CP860 IP conference phone. To place a new
call during an active call, do one of the following:
-
Press . The active call is placed on hold.
Enter the desired number using the keypad.
Press , , or the Send soft key.
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone,
press the OK key when the phone is idle. The maximum length of SIP URI or IP address
length is 32 characters. For example, SIP URI: [email protected], IP: 192.168.1.15.
Your phone may not support direct IP dialing. Contact your system administrator for more
information.
Содержание CP860 SERIES
