YASKAWA PROFINET V1000, Быстрый старт

Страница: 127 / 231

No. Checklist Page
10 The should illuminate after giving a run command. –
11
To give a run command and frequency reference from the LED Digital Operator, press
to set to LOCAL. The LO/RE key lights while LOCAL is displayed.
88
12
If the motor rotates in the opposite direction during the test run, switch two of the drive
output terminals (U/T1, V/T2, W/T3).
95
13 Select the correct duty rating (C6-01) for the application. –
14
Set the correct values for the motor rated current (E2-01) and the motor protection
selection (L1-01) to ensure motor thermal protection.
–
15
If the run command and frequency reference are provided via the control circuit
terminals, set the drive for REMOTE and be sure the LO/RE light is out.
88
16
If the control circuit terminals should supply the frequency reference, select the correct
voltage input signal level (0 to 10 V) or the correct current input signal level (4 to 20
mA or 0 to 20 mA).
88
17 Set the proper voltage to terminal A1. (0 to 10 V). –
18 Set the proper current to terminal A2. (4 to 20 mA or 0 to 20 mA). –
19
When current input is used, set H3-09 to “2” (4 to 20 mA) or “3” (0 to 20 mA) and set
H3-10 to “0”.
–
20
When current input is used, switch the drive built-in DIP switch S1 from the V-side
(OFF) to I-side (ON).
–
21
Set the minimum and maximum frequency references to the desired values. Make the
following adjustments if the drive does not operate as expected:
Gain adjustment: Set the maximum voltage/current signal and adjust the analog input
gain (H3-03 for input A1, H3-11 for input A2) until the frequency reference value
reaches the desired value.
Bias adjustment: Set the minimum voltage/current signal and adjust the analog input
bias (H3-04 for input A1, H3-12 for input A2) until the frequency reference value reaches
the desired minimum value.
–
4.10 Test Run Checklist
YASKAWA ELECTRIC TOEP C710606 47A YASKAWA AC Drive – V1000 Quick Start Guide 127
4
Start-Up Programming & Operation