3.2
IGRIP V5-RRS/RCS-Module Connection Operation
To connect the NX100 RCS-Module with the RRS function of IGRIP and run a simulation, it is
required to perform the "Start-up of the RCS Server Program" and the "IGRIP-RRS
Connection Operation".
3.2.1
Preparation
RRS server definition is in the file "rrs.servers" located under "\intel_a\startup\rrs" which is
located under the folder where IGRIP was installed. Add the host name of your server
machine in this file. The format description is as follows:
Server definition: <RRS_Server><RRS_Cntr_Type>SOCKET<Host><Port>
If the host name is "IGRIP", the definition is written as follows:
# YASKAWA NX100 1.XX Servers
#
YASKAWA_NX100
__
1.XX_Server1 YASKAWA_NX100
__
1.XX SOCKET Lynxdeu 4500
YASKAWA_NX100
__
1.XX_Server2 YASKAWA_NX100
__
1.XX SOCKET rcssrvr
4500
YASKAWA_NX100
__
1.XX_Server3 YASKAWA_NX100
__
1.XX SOCKET IGRIP
4500
Fig. 3-6 Example of the RRS server settings
Note) The modification on "rrs.servers" file after launching the IGRIP will not be reflected.
3.2.2
Setup of the IGRIP V5 RRS property
After the installation, it is necessary to set the installation location of the RCS module in IGRIP
V5. To do so, please follow the procedure below:
1)
In IGRIP V5, select [Tools]-[Options] to display the "Options" dialog box.
2)
Click on [Ressource Detailing] in tree structure on the left side of the "Options" dialog
box.
3)
Click on the [RRS] tab on the right side of the "Options" dialog box
Atfer completing the above steps, the "Options" dialog box should look like the figure below.
23/31
HW0482335
