Yanmar 6LPA-STP2, Руководство по обслуживанию

Страница: 128 / 318

ENGINE
5-48 6LPA Service Manual
Cylinder Block
© 2007 Yanmar Marine International
Note: Replace the old bearings with new
bearings of the same number. If the
bearing number is unknown, it may be
determined by adding the numbers on
the main bearing cap and crankshaft and
select a bearing having a number equal
to that obtained by addition. There are
five types of standard bearings, which
are identified by marks “2”, “3”, “4”, 5”
and “6” (Figure 5-97).
Figure 5-97
Figure 5-97
1 – No. 1
2 – No. 2
3 – No. 3
4 – No. 4
5 – No. 5
6 – No. 6
7 – No. 7
8 – Mark 1, 2, 3, 4 or 5
9 – Mark 1, 2 or 3
10 – Mark 2, 3, 4, 5 or 6
Example: If the numbers on the main bearing cap
and crankshaft are (2) and (1), select bearing (3)
as (2 + 1 = 3).
(1)
(2)
(5)
(6)
(7)
( 8 )
(4)
( 3 )
(2)
( 3 )
(4)
(7)
(6)
(5)
(9)
(1)
(10)
0004 8 79
Crank Journal Bearing Selection Table
Mark No.
Main bearing cap 1 2 3
Crankshaft 1 2 3 1 2 3 1 2 3
Bearing 2 3 4 3 4 5 4 5 6
Cylinder Block Journal Bore Diameter
Mark “1” 71.000 to 71.006 mm
(2.7952 to 2.7955 in.)
Mark “2” 71.006 to 71.012 mm
(2.7955 to 2.7957 in.)
Mark “3” 71.012 to 71.018 mm
(2.7957 to 2.7959 in.)
Crankshaft Journal Diameter
Mark “1” 66.994 to 67.000 mm
(2.6375 to 2.6377 in.)
Mark “2” 66.988 to 66.994 mm
(2.6377 to 2.6375 in.)
Mark “3” 66.982 to 66.988 mm
(2.6370 to 2.6373 in.
Crank Journal Bearing Thickness and P/N
Mark “2” 1.979 to 1.982 mm
(0.0779 to 0.0780 in.)
-
Mark “3” 1.982 to 1.985 mm
(0.0780 to 0.0781 in.) P/N: 119770-00961
Mark “4” 1.985 to 1.988 mm
(0.0781 to 0.0782 in.) 119770-00971
Mark “5” 1.988 to 1.991 mm
0.0782 to 0.0783 in.) 119770-00981
Mark “6” 1.991 to 1.994 mm
(0.0783 to 0.0786 in.) 119770-00991
Mark “7” 1.994 to 1.997 mm
(0.0785 to 0.0786 in.) 119770-01001
Mark “8” 1.997 to 2.000 mm
(0.0786 to 0.0787 in.) 119770-01170