Yanmar 6LPA-STP2, Руководство по обслуживанию

Страница: 131 / 318

ENGINE
6LPA Service Manual 5-51
Cylinder Block
12/05
© 2007 Yanmar Marine International
27. Completely remove the plastigage.
28. Lift and remove the crankshaft (Figure 5-98).
Figure 5-98
Figure 5-98
29. Remove the upper bearing and thrust bearing
from the cylinder block.
Keep the main bearing and thrust bearing
together in order for reassembly.
30. Remove the check valve and oil nozzle (for
piston cooling). See Oil Nozzle Disassembly
and Inspection on page 8-17.
Cylinder Block Inspection
1. Use a scraper to remove any remaining gasket
material from the top of the cylinder block
(Figure 5-99).
Figure 5-99
Figure 5-99
2. Thoroughly clean the cylinder block using a soft
brush and solvent.
3. Measure the top deck surface of the cylinder
block using a precision straight edge and feeler
gauge (Figure 5-100).
• Maximum warpage is 0.20 mm (0.008 in.)
If the measured warpage exceeds the maximum,
replace the cylinder block.
Figure 5-100
Figure 5-100
4. Visually check the cylinders for vertical
scratches. If deep scratches are present, bore
the cylinders or replace as needed
(Figure 5-101).
Figure 5-101
Figure 5-101
0004 88 0
0005022
000502 3
0005024