Yanmar 6LPA-STP2, Руководство по обслуживанию

Страница: 305 / 318

ALTERNATOR
6LPA Service Manual 11-19
Alternator Service
12/05
© 2007 Yanmar Marine International
6. Using the special nut holder tool
(Figure 11-39, ((1)) installed into a vice, torque
the pulley nut with special tool
(Figure 11-39, (2)) to: 1.125 kgf·cm,
110.32 N·m (81.3 lb-ft).
Figure 11-39
Figure 11-39
7. Install the rectifier holder and 4 rubber
insulators (Figure 11-40, (1)) above lead wires.
Figure 11-40
Figure 11-40
8. Install the rectifier holder (Figure 11-41, (2))
with 4 bolts (Figure 11-41, (1)) while pushing it
downwards. Torque bolts to: 30 kgf·cm,
2.94 N·m (26.0 lb-in.).
Figure 11-41
Figure 11-41
9. Install the seal plate on the rectifier end frame
and then the IC regulator and brush holder in
an upward direction (Figure 11-42).
10. Tighten the 5 bolts and then install the brush
holder cover above the brush holder.
Figure 11-42
Figure 11-42
0004 8 65
(1)
(1)
(2)
0004 838
(1)
0004 83 7
(1)
(2)
(1)
(1)
(1)
0004 8 6 8