Yanmar 6LPA-STP2, Руководство по обслуживанию

Страница: 36 / 318

GENERAL SERVICE INFORMATION
3-24 6LPA Service Manual
Engine Coolant
© 2007 Yanmar Marine International
Checking and Adding Power Steering
Oil (6LPA-STZP2 Models)
Figure 3-23
Figure 3-23
1 – Power Steering Oil Service Tank
2 – Lower Oil Level
3 – Upper Oil Level
4 – Filler Cap / Dipstick
1. Remove the filler cap / dipstick
(Figure 3-23, (4)) from the power steering oil
service tank (Figure 3-23, (1)) and wipe with a
clean cloth.
2. Fully reinsert the dipstick.
3. Remove the dipstick. The oil level should be
between upper (Figure 3-23, (3)) and lower
(Figure 3-23, (2)) lines on the dipstick.
4. Fill with oil to the upper limit on the dipstick. See
Mercruiser® Bravo Stern Drive Oil
Specifications on page 3-23. NOTICE: NEVER
overfill the power steering system with oil.
5. Fully reinsert the dipstick and hand tighten.
ENGINE COOLANT
Engine Coolant Specifications
• Texaco Long Life Coolant (LLC), both standard
and premixed, product code 7997 and 7998
• Havoline Extended Life Antifreeze / Coolant,
product code 7994
Note: In the U.S., LLC is required for the
warranty to be valid.
NOTICE:
• Always add LLC to soft water - especially when
operating in cold weather. Without LLC, cooling
performance will decrease due to scale and rust
in the cooling system. Water alone may freeze
and form ice; it expands approximately 9% in
volume.
• Use the proper amount of coolant concentrate for
the ambient temperature as specified by the LLC
manufacturer. LLC concentration should be a
minimum of 30% to a maximum of 60%. Too
much LLC will decrease the cooling efficiency
also. NEVER mix different types or brands of LLC
or a harmful sludge may form.
• NEVER use hard water. Water should be clean
and free from sludge or particles.
• Following the manufacturer’s recommendations,
use a proper LLC which will not have any adverse
effects on the materials (cast iron, aluminum,
copper, etc.) of the engine’s freshwater cooling
system.
• Excessive use of antifreeze also lowers the
cooling efficiency of the engine. Be sure to use
the mixing ratios specified by the antifreeze
manufacturer for the temperature range.
• Replace engine coolant periodically, according to
the maintenance schedule.
• Remove scale from the cooling system
periodically by flushing the system. NEVER mix
different brands of antifreeze. Chemical reactions
may make the antifreeze useless and engine
problems may result.
(1)
(4)
( 3 )
(2)
0004912_ s 1