Yamato BM500, Инструкция по эксплуатации

Страница: 26 / 45

23
4. OPERATION PROCEDURES
Auto Start Mode
Auto Start mode allows an automatic start time to be set in advance of operation.
Auto start
operation procedures
1. Turn ON main power switch.

When power switch is turned ON, display shows initial values
for about four seconds before entering standby, which shows
current bath temperature in display.

See
“Display Characters” (P.14).
2. Set temperature

Set the desired temperature using
△▽
.
Press
△
or
▽
. Temperature setting is shown. Press
△
to
increase value. Press
▽
to decrease value.
After three seconds, display will revert to current bath
temperature (standby).
3. Set auto start timer

Press TIMER and select [Astr].
Display shows [Astr] and timer setting alternately.
Set auto start time using
△▽
.
4. Start operation

Press and hold START/STOP.
Auto start operation begins and the operation lamp flashes.
The HEATER lamp lights and temperature begins building at the
preset time.
Current temperature and remaining time until start are
alternately shown in display.
Temperature reading/setting display:
Current bath temperature is displayed in standby.