Yamato BM500, Инструкция по эксплуатации

Страница: 21 / 45

18
4. OPERATION PROCEDURES
Constant Temperature Mode
Constant Temperature mode is a general use, continuous operation mode (started/stopped manually).
Constant temperature
operation procedures
1. Turn ON main power switch.

When power switch is turned ON, display shows initial values
for about four seconds before entering standby, which shows
current bath temperature in display.

See
“Display Characters” (P.14).
2. Set temperature

Set the desired temperature using
△▽
.
Press
△
or
▽
. Temperature setting is shown. Press
△
to
increase value. Press
▽
to decrease value.
After three seconds, display will revert to current bath
temperature (standby).
CAUTION: If hot water is added during operation, bringing
temperature to 40°C or more beyond temperature setting, the unit
interprets this as an overheating event. Power is cut to the heater,
and error 6 is displayed. If bath water level becomes too low while
unit is running, cancel operation before adding.
3. Start operation

Press and hold START/STOP.
Operation begins. The operation and HEATER lamps light and
temperature begins to build.
4. Stop operation

Press and hold START/STOP.
Operation stops. The operation and HEATER lamps go out.
The display reverts to standby (current bath temperature).
Correcting or viewing settings.
Use
△▽
at any time to correct or view settings.
Press either
△
or
▽
once to view temperature setting. Display will automatically revert to temperature
reading after 4 seconds. To change the setting, continue operating
△▽
until desired temperature is
entered. Unit will continue operation under new temperature setting.
Temperature reading/setting display:
Current bath temperature is displayed in standby.