21
4. OPERATION PROCEDURES
Auto Stop Mode
Auto Stop mode allows an automatic stop time to be set in advance of operation.
Auto stop
operation procedures
1. Turn ON main power switch.
When power switch is turned ON, display shows initial values
for about four seconds before entering standby, which shows
current bath temperature in display.
See
“Display Characters” (P.14).
2. Set temperature
Set the desired temperature using
△▽
.
Press
△
or
▽
. Temperature setting is shown. Press
△
to
increase value. Press
▽
to decrease value.
After three seconds, display will revert to current bath
temperature (standby).
3. Set auto stop timer
Press TIMER and select [AstP].
The screen displays [AstP] and timer setting alternately.
Set auto stop time using
△▽
.
4. Start operation
Press and hold START/STOP.
The operation lamp flashes and quick auto stop operation
begins.
When bath temperature reaches temperature setting, the timer
begins and timed operation starts. From this point, the display
shows current bath temperature and remaining time alternately.
5. End of operation
Operation automatically stops at the preset time.
Display reverts to standby (current time) and HEATER lamp
goes out.
Temperature reading/setting display:
Current bath temperature is displayed in standby.
Содержание BM500
Страница 2: ......
