Yamaha YZF-R6, Руководство по обслуживанию

Страница: 64 / 425

2-38
C Fasten the handlebar switch leads (left and right)
and main switch lead with a band.
D Route the ignition coil lead and handlebar switch
leads (left and right) over the heat protection plate.
E Route the reservoir tank hose, carburetor heater
hoses under the heat protector plate.
F Fasten the neutral switch lead, right handlebar
switch lead, main switch lead, TPS lead, left han-
dlebar switch lead, pickup coil lead and throttle
stop screw cable with a band.
G Insert the projection of the band to the hole of the
frame and fasten the wireharness, neutral switch
lead, handlebar switch leads (left and right), main
switch lead, throttle position sensor lead, rear
brake switch lead and pickup coil lead with them.
CABLE ROUTING
SPEC
H Route the starter motor lead under the wirehar-
ness.
I Fasten the starter motor to the rear fender with a
band.
J Fasten the battery positive (+) cable and starter
motor cable with a plastic band.
K Position the rear turn signal light connectors (left
and right) and taillight connector between the rear
fender and taillight bracket.
L Install the seat lock cable to the frame bracket with
protector side.
M Fasten the wireharness, oil level sensor lead,
ground lead and alarm leads (3 lines) with a band.
N Fasten the starter relay lead and battery negative
(–) lead to the wireharness with a plastic band.
O Fasten the battery negative (–) lead and wirehar-
ness with a plastic band.