Yamaha TT-R125(S) 2003, Руководство по эксплуатации для владельца

Страница: 230 / 610

3 - 29
INSP
ADJ
●
Tighten the lower ring nut 6 using steer-
ing nut wrench 7 and turn the steering
right and left a few times.
NOTE:
Set the torque wrench to the steering nut
wrench so that they form a right angle.
Steering nut wrench:
YU-33975/90890-01403
T
R
.
.
Lower ring nut (initial tightening):
38 Nm (3.8 m • kg, 27 ft • lb)
●
Loosen the lower ring nut one turn.
●
Retighten the lower ring nut using the
steering nut wrench.
WARNING
Avoid over-tightening.
T
R
.
.
Ring nut (final tightening):
20 Nm (2.0 m • kg, 14 ft • lb)
●
Check the steering stem by turning it lock
to lock. If there is any binding, remove the
steering stem assembly and inspect the
steering bearings.
●
Install the rubber washer 8 , upper ring
nut 9 and special washer 0 .
NOTE:
●
Tighten the upper ring nut until it contacts
the rubber washer.
●
Insert the special washer pawls into the
slots. If the slots are not aligned, tighten
the upper ring nut for alignment.
STEERING HEAD INSPECTION AND ADJUSTMENT