Yamaha FZ-16 2015, Руководство по обслуживанию

Страница: 112 / 267

4-33
MANILLAR
1
to
4. Assembly:
•
Switch front brake light "1"
NOTE:
Align the projection "a" on the left handlebar switch
with the hole "b" on the handlebars.
to
6. Assembly:
• Clutch Cable
NOTE:
Lubricate the clutch cable end with a thin layer of
grease lithium soap base.
7.
Assembly:
1
b
•
brake master cylinder
•
Clamp brake master cylinder
See the "BRAKE
FRONT "on page 4-23.
8.
Assembly:
• l Throttle grip "1"
5.
Assembly:
•
Left handlebar "1"
•
Handlebar cap "1"
a.
Apply a thin layer of rubber adhesive on the left
end of the handlebar.
b.
Slide the handlebar handle at the left end
of the handlebar.
c.
Wipe off any excess rubber adhesive with a clean
cloth.
WARNING Do
not touch the handlebar grip until the rubber adhesive
is completely dry.
NOTE:
There should be less than 3 mm of clearance
"a" between the handlebar handle and the end
Handlebar
㻚
• The throttle cable "2"
• The right handlebar switch "3"
• Handlebar Plug
NOTE:
•
Lubricate the throttle cable end and the inside of
the throttle grip with a thin layer of grease
based on lithium soap and then install the
handlebar grip.
• Route the throttle cable through the slot on the right
handlebar switch, then install the cable.
•
Align the projection "a" on the right handlebar
switch with the hole "b" on the handlebars.
• Must have 1-3 mm of clearance "c" between the
handlebar grip and handlebar end
㻚