Yamaha FZ-16 2015, Руководство по обслуживанию

Страница: 178 / 267

EMBRAGUE
5-41
5. Fold the tab washer along a flat side of the nut.
6.
Lubricate:
• Friction Plates
•
Clutch discs
(With the recommended lubricant)
Recommended lubricant
Engine Oil
2
1
9. Fit:
•
Free play of the clutch mechanism
a. Verify that the projection "a" on the clutch lever "1" is
aligned with the mark "b" shown in the illustration of
the crankcase, pushing the clutch lever manually
push in the direction "c" until it stops.
7. Install:
•
Seat cushion spring
Clutch "1"
to
c
•
Clutch damper spring "2"
•
Two friction discs
b
•
Clutch discs
1
• Friction Plates 1
NOTE:
• Install the seat cushion clutch spring and
damper spring clutch as shown in the
illustration.
•
First, install a friction disk and then switch
between a clutch plate and friction disc.
b.
If the projection "a" is not aligned with the
mark "b", aligned as follows:
• Loosen the locknut "2".
•
With the push lever clutch completely pushed
in the direction "c", turn the push rod clutch
short "3" inward or outward until the
projection "a" is aligned with the mark "b".
• Hold the short rod thrust
1 2
clutch to keep it from moving and tighten the
locknut to specifications.
Nut (short push rod clutch)
8 Nm (0.8 m · kg, 5.8 ft · lb)
8.
Install:
• Pressure Plate
•
Clutch springs "1"
•
Screws clutch springs "2"
2
Screws clutch springs
8 Nm (0.8 m · kg, 6 ft · lb)
NOTE:
3
Tighten the clutch springs in stages and in a
crisscross pattern.