Yamaha F75D, Руководство пользователя

Страница: 24 / 75

Basic components
19
EMU26620
Trim meter (digital type)
This meter shows the trim angle of your out-
board motor.
NOTE:
●
Memorize the trim angles that work best for
your boat under different conditions. Adjust
the trim angle to the desired using the pow-
er trim and tilt switch.
●
If the trim angle of your motor exceeds the
trim operating range, the top segment on
the trim meter display will blink.
EMU26650
Hour meter (digital type)
This meter shows the number of hours the en-
gine has been run. It can be set to show the
total number of hours or the number of hours
for the current trip. The display can also be
turned on and off.
●
Changing the display format
Pressing the “
” (mode) button chang-
es the display format in the following pat-
tern:
Total hours
→
Trip hours
→
Display off
●
Resetting the trip hours
Simultaneously pressing the “
” (set) and
“ ” (mode) buttons for more than 1 sec-
ond while the trip hours are displayed re-
sets the trip counter to 0 (zero).
NOTE:
The total number of hours the engine has
been run cannot be reset.
EMU26690
Trip meter
This gauge displays the distance the boat has
traveled since the gauge was last reset.
Press the “
” (mode) button repeatedly
until the indicator on the face of the gauge
points to “
” (trip). To reset the trip meter to
zero, press the “ ” (set) and “ ” (mode)
buttons at the same time.
NOTE:
●
The trip distance is shown in kilometers or
miles depending upon the unit of measure-
ment selected for the speedometer.
●
The trip distance is kept in memory by bat-
tery power. The stored data will be lost if the
battery is disconnected.
ZMU01740
ZMU01741
U6D610E0.book Page 19 Tuesday, April 20, 2004 1:52 PM