Yamaha F150A, Руководство по обслуживанию

Страница: 87 / 493

3-18
Optional equipment
0
1
2
3
4
5
6
7
8
9
10
A
14. Route the tilt limiter lead “1” in the same
manner as the trim sensor lead “2”, and
then fasten them using new plastic ties
“3” at the positions where original plastic
ties were installed.
15. Route the tilt limiter lead “1” and PTT
motor lead “2”, and then fasten them
using the holders “3” and “4”.
16. Remove the yellow tape “1”.
17. Disconnect the tilt limiter coupler “a” and
remove the cap “b”.
18. Connect the tilt limiter couplers of the
main harness side with the tilt limiter cou-
plers “a” of the tilt limiter side of the same
wire colors.
19. Connect the PTT motor leads “1”, and
then tighten the PTT motor lead bolt “2”
to the specified torque.
20. Connect the battery cables “3”, and then
tighten the battery cable nut “4” to the
specified torque.
21. Install the rubber cap “5”.
22. Install the junction box cover.
Setting the tilt limiter
• Check that the outboard motor is
mounted securely.
• Never get under the outboard motor
while it is tilted.
1
2
3
3
3
4
3
2
1
1
a
b
PTT motor lead bolt “2”:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
Battery cable nut “4”:
9 N·m (0.9 kgf·m, 6.6 ft·lb)
Sb
Sb
B
B
L
a
a
3
2
1
4
5