Yaesu VR-5000, Руководство по эксплуатации

Страница: 33 / 64

VR-5000 O
PERATING
M
ANUAL
31
Scanning
VOICE Scanning
1. Press the [
F
] key momentarily, then press the [
V/M
(
MW
) ] key.
2. Rotate the DIAL knob to set the cursor to the “
Channel
” menu option, then press the
[
ENT
(
SET
) ] key.
3. Using the [
( )/ ( )] keys or the keypad, select the memory bank on which you
wish to perform VOICE scanning, then press the [
BANK
] key.
4. Rotate the DIAL knob to set the cursor to the
“ VCS ” menu option, then press the [
•
(
BEEP
) ]
key to enable VOICE scanning.
5. Rotate the
DIAL
knob to set the cursor to the
“
E N D
” m e n u o p t i o n , t h e n p r e s s t h e
[
ENT
(
SET
) ] key.
6. Confirm that the cursor is on the “ WRITE ”
menu option, then press the [
ENT
(
SET
) ] key to save the new setting and exit to normal
operation.
Setting the Scan-Resume Technique
Three options for the Scan-Resume technique are available. These options may be set
independently for Memory Scan, VFO Scan, and PMS (Band-Segment) Scan operation.
DELAY
: In this mode, the scanner will halt on a signal it encounters, and will hold until the
signal disappears. After the squelch closes when the received station quits trans-
mitting, scanning resumes automatically. The scanning-restart delay time (default
interval: 2 seconds) is set by the “
M-P.DELAY ” menu selection.
PAUSE
: In this mode, the scanner will halt on a signal it encounters. After a programmed
time interval (set by the “ M-PAUSE ” menu selection), the scanner will resume,
whether or not the signal has disappeared.
HOLD : In this mode, the scanner will halt on a signal it encounters. It will not restart
automatically; you must manually re-initiate scanning if you wish to resume.
However, the “
M-HOLD ” menu selection provides a “restart” window within which,
if the incoming signal disappears, the scanner will resume; this allows scanning to
proceed if the squelch is opened by a brief incoming signal burst.
Here is the procedure for setting up the Scan-Resume mode for Memory scanning:
1. Press the [
V/M
(
MW
)
] key, if necessary, to enter the “
MR
” (Memory Recall) mode.
2. Use the [
( )/ ( )] keys to select the desired memory bank.
3. Press the [
BANK
] key, then rotate the dial to select the “
ScanStop ” menu option.
4. Press the [ •
(
BEEP
) ] key, repeatedly if necessary, to select “
DELAY ,” “ PAUSE ,” or
“ HOLD ,” as desired.
5. Rotate the DIAL knob to select “ END ,” then press the [ ENT
(
SET
) ] key.
6. The display should now indicate “ WRITE ;” press the [
ENT
(
SET
)
] key again to save
the new setting and exit to normal operation .