Yaesu VR-5000, Руководство по эксплуатации

Страница: 55 / 64

VR-5000 O
PERATING
M
ANUAL
53
The VR-5000 includes a convenient “Clone” feature, which allows the memory and con-
figuration data from one receiver to be transferred to another
VR-5000
. Here is the proce-
dure for Cloning one radio’s data to another:
1. Set both radio’s baud rate to the same rate, such as “”57,600 bps,” per the following
steps:
(1) Press the [
F
] key momentarily, then press the [
ENT
(
SET
) ] key.
(2) Rotate the
DIAL
knob to set the cursor to the “ CAT RATE ” menu option, then press
the [ ENT
(
SET
) ] key.
(3) Rotate the
DIAL
knob to set the cursor to the desired rate (4800/9600/57600 bps),
then press the [ ENT
(
SET
) ] key.
(4) Confirm that the cursor is on the “ END ” menu option, then press the [
ENT
(
SET
) ]
key.
(5) Confirm that the cursor is on the “ WRITE ” menu option, then press the [
ENT
(
SET
)
]
key.
2. Turn both radios off.
3. Connect the a (D-SUB 9-pin) RS-232C cross cable (not supplied) between the
CAT
jacks on the rear panels of the two radios.
4. Turn the Destination radio on (“ CLONE SLAVE ” will appear on the LCD), then turn the
Source radio on (“ CLONE MASTER ” will appear on the LCD).
5. Press the [ COPY
(
REC
)
] key on the
Source radio; “ WRITE ” will appear on the Source
radio, and the data transfer will commence.
6. If the data transfer is successful, “ COMPLETE ” will appear on both radios. Turn both
radios off and disconnect the RS-232C cross cable. You can then turn the radios back
on, and begin normal operation.
Cloning
ANT A ANT A
CAT CAT
IF OUT IF OUT
ANT ANT
A A B B
+8V +8V REC REC EXT SP EXT SP
ANT B ANT B
MUTE MUTE
DC 13.5V DC 13.5V
RS-232C Cross Cable