Yaesu FTM-200DR, Руководство для продвинутых пользователей

Страница: 35 / 67

35
9. Rotate the DIAL knob to select the band to be used for the packet communication
then press the DIAL knob.
The setting changes in the following order:
MAIN BAND

SUB BAND

A-BAND FIX

B-BAND FIX

...
• Refer to “67 DATA BAND” (page 58) for details.
• Factory default value: B-BAND FIX
10. Press the [ SQL
BACK
] key.
11. Rotate the DIAL knob to select [ 68 DATA SPEED ] then press the DIAL knob.
12. Rotate the DIAL knob to select [ DATA ] then press the DIAL knob.
13. Rotate the DIAL knob to select the packet communication speed.
The setting will switch between “1200 bps” and “9600 bps” then press the DIAL knob.
Factory default value: 1200bps
14. Press the [ SQL
BACK
] key.
15. Rotate the
DIAL
knob to select [
69 DATA SQL
] then press the
DIAL
knob.
16. Rotate the DIAL knob to select the squelch detection method for the packet
communication.
The setting switches between “TX OFF” and “TX ON”.
• Refer to “69 DATA SQL” (page 59) for details.
• Factory default value: TX ON
17. Press any key (except Power Switch) or PTT switch to complete the setting and return
to the original screen.
This completes the packet communication settings.
When transmitting a large volume of packet data, the transmission time gets longer, and
the transceiver may heat up. When transmission continues for a long period of time, the
overheating prevention circuit will act to lower the transmit power output. When transmission
is continued further, transmission will be suspended automatically, and the transceiver will go
into the receive mode to prevent failure due to overheating. When the overheating prevention
circuit is activated and the radio goes into the receive mode, either switch the power OFF, or
wait in receive mode until the transceiver cools.