Yaesu FT DX 9000MP CONTEST - DATA MANAGEMENT..., Руководство по эксплуатации

Страница: 138 / 180

Page 136 FT
DX
9000MP O
PERATION
M
ANUAL
M
EMORY
S
CAN
1. Set the transceiver up in the memory mode by press-
ing the [ V/M
] key, if necessary.
2. Rotate the Main (VFO-A) receiver’s [ SQL
] control
so that the background noise is just silenced.
3. Press and hold in the microphone’s [ UP
] or [
DOWN
]
key for 2 second to start scanning in the specified di-
rection.
If the scanner halts on an incoming signal, the deci-
mal point between the “MHz” and “kHz” digits of
the frequency display will blink.
If the incoming signal disappears, scanning will
resume in about five seconds.
Q Q
Q Q
Q
UICK UICK UICK UICK UICK
P P
P P
P
OINT OINT OINT OINT OINT
If you have no interest in scanning, and wish to
prohibit the microphone’s [
UP
]/[
DOWN
] keys
from initiating scanning, you may disable scanning
control from the microphone using Menu Item
“
GENERAL 044 MIC SCAN ” (set it to “DIS-
ABLE”).
VFO VFO
VFO VFO
VFO
AND AND
AND AND AND
M M M M M
EMOR EMOR
EMOR EMOR EMORYYYYY
S S S S S
CANNING CANNING
CANNING CANNING CANNING
A A
A A A
D D D D DVICE VICE VICE VICE VICE
During Memory Group operation, only the
channels within the current Memory Group will
be scanned.
If the scan has paused on a signal, pressing the
microphone’s [ UP
] or [
DOWN
] key will cause
scanning to resume instantly.
If you press the microphone’s PTT switch dur-
ing scanning, the scanner will halt at once. Press-
ing the PTT switch during scanning will not
cause transmission, however.
You may select the manner in which the scan-
ner resumes while it has paused on a signal,
using Menu item “
GENERAL 045 MIC SCAN
RESUME ”. During memory scanning, the de-
fault “TIME” setting will cause the scanner to
resume scanning after five seconds; you may
change it, however, to resume only after the
carier has dropped out, if you like See page
151 .
[SQL] Knob
VDD TEMP SWR BIAS
[V/M] Switch