Yaesu FT DX 9000MP CONTEST - DATA MANAGEMENT..., Руководство по эксплуатации

Страница: 121 / 180

Page 119 FT
DX
9000MP O
PERATION
M
ANUAL
CW C CW C
CW C CW C
CW C
ONVENIENCE ONVENIENCE
ONVENIENCE ONVENIENCE ONVENIENCE
F F F F F
EA EA
EA EA EATURES
TURES
TURES TURES TURES
C
ONTEST
M
EMORY
K
EYER
Text Message Programming
1. Press the [ CW
] Mode key to set the operating mode
to CW.
2. Be sure that Break-in is Off by pressing the [
BK-IN/
SPOT
] key, if necessary.
3. Press the FH-2 ’s [ MEM
] key.
Checking the CW Memory Contents
1. Be sure that Break-in is still turned Off.
2. Press the
FH-2 ’s [ 1
] ~ [
5
] key to check your work.
You will hear the results in the sidetone, but no RF
energy will be transmitted.
LOCK
OFF ON
LOCK
OFF ON
LOCK
OFF ON
LOCK
OFF ON
LOCK
OFF ON
4. Press the FH-2 ’s [ 1
] ~ [
5
] key to select the desired
Message Memory Register into which you wish to pro-
gram the text.
5. Use the FH-2 ’s [
] amd [ ] keys to set the cursor
position and use the [ ] and [ ] keys to choose the
letter/number to be programmed in each slot of the
memory. In the case of the second example above, the
“}” character designates the slot where the Contest
Number will appear.
A A A A A
D D D D DVICE VICE VICE VICE VICE
:
You may also use the [ MAIN Tuning Dial
] knob and
the [ CLAR/VFO-B
] knobs to program the message
characters.
6. Press the
FH-2
’s [
MEM
] key again once all charac-
ters have been programmed.
On-The-Air CW Message Playback
1. Press the [ BK-IN/SPOT
] key to enable transmission.
Either Full- or Semi-break-in will be engaged, depend-
ing on the setting of Menu item “
MODE-CW 055
CW BK-IN ”.
2. Press the FH-2 ’s [ 1
] ~ [
5
] key to transmit the pro-
grammed message.
N N N N N
O O O O OTE TE TE TE TE
:
If you subsequently decide to use the “MESSAGE” tech-
nique for memory storage, please note that the contents of
a message stored using text input will not be transferred
over when you select “MESSAGE” on a particular memory
register.
Correcting/Editing
Previously-Stored Characters
Use the [ Main Tuning Dial
] knob to select the
letter/number to be corrected, then rotate the
[
CLAR/VFO-B
] knob to choose the revised let-
ter/number top be utilized in this slot.
Deleting Previously-stored Characters
Use the [ MAIN Tuning Dial
] knob to select the
last correct letter in the message. Now rotate the
[
CLAR/VFO-B
] knob to select the “
} ” character;
everything after the “ } ” character will be deleted.