Xycom XVME-240, Руководство пользователя

Страница: 39 / 73

XVME-240 Manual
October, 1984
Interrupts Pending register shows which interrupts in particular (input lines) are
pending.
As mentioned in the previous section (Section 3.3.6), the contents of the interrupt
input
latch and the Interrupt Mask
Register are logically ANDed. The Interrupts
Pending Register contains the result
of this AND operation for each interrupt input
line.
Each
bit in the Interrupts Pending
Register corresponds to one of the interrupt input
lines. Figure 3-7 is a bit map of
the Interrupts Pending Register.
INTERRUPTS PENDING REGISTER (Base A 82H)
.
Bit
Bit Bit Bit Bit Bit Bit
l
Bit
7 6 5 4
3
2 1 0
Interrupt Input 4
Interrupt Input 5
Interrupt Input 6
Interrupt Input 7
Logic " 1 " = A Pending Interrupt.
Logic " 0 " = No Pending Interrupt.
Figure 3-7. Interrupts Pending Register
When reading the Interrupts Pending Register (Base a 82H), a bit containing a
"1" means that the corresponding interrupt input has a pending interrupt. When a
register bit
is set to " 0 " it means that the corresponding interrupt input has no pending
interrupt.
.
It is possible for
several interrupt inputs to have interrupts pending at one time. In
this case, the
user software/firmware will have to prioritize the interrupting devices
to
establish an
interrupt handling order.
3.3.8 Interrupt Vector Register
(Base Address + 85H)
This read/write register
is used to
hold the interrupt service vector which will be
transmitted to the
system processor during the interrupt acknowledge sequence,
allowing automatic entry
into a
service
routine
without
device polling. This is an 8-bit
register arranged with the
MSB
and
the LSB
as shown in Figure 3-8.
3-12