28
Version 1 – GBR (11/05/2022)
D-502-0260
1.
receiver status
2.
synchronization
(receiver-thermostat)
3.
Manual switching
M
- testing the heating functionality
4.2.1.
Power control terminals
-
description of terminals given in Chapter 3.9.2. and 3.9.3
4.2.2.
receiver of the signal from the wireless room thermostat:
-
the receiver is integrated in the curtain regulation and it can be used for indication - setting of:
4.2.3.
Wireless room thermostat
-
allows setting the desired temperature from 5 to 30°C. Based on the difference between the ambient
temperature and the desired temperature, the curtain is switched off and on at the lowest speed together
with the heater. In the case of the electric version, the PTC electrical heaters are switched on/off and in
the case of the water version, the contact to control the valve actuator is switched on/off.
-
Description of the basic functions of the thermostat:
4.2.4.
Pairing multiple curtains with a single wireless thermostat
-
Pairing multiple receivers - curtains with a single wireless thermostat is done in the same way as pairing
one receiver with one thermostat according to the separate instructions included in the thermostat
package.
-
Press the pairing buttons on all regulated receivers - curtains that you want to pair to a single wireless
thermostat
o
The signal LEDs on receivers turn green and will be flashing for about 1 min
-
Next, follow the separate instructions included with the wireless thermostat.
Section 12 - Thermostat and
receiver synchronization
-
If you have not managed to pair within 1 min - the LED on the receiver is lit. Repeat the procedure.
4.2.5.
Curtain switch-off delay device
-
It is used to set the delay of the fan switching off after closing the shielded opening. The delay time can
be set from 1 s up to 20 min using switching sliders (coarse setting) and a potentiometer (fine setting).
-
Factory setting of delay approx. 10 sec. The pre-set delay should respect the frequency of the door
opening so that the curtain is not constantly switching on and off. Setting the delay time too short can
limit the functionality (heating, shielding) of the curtain and shorten the lifetime of the device.
4.2.6.
Magnetic door contact
-
Used for switching the curtain to the shielding level - performance (Chapter 4.2.8.1.) set according to the
size of the shielded opening.
-
Contact supply 230 VAC. Switching logic NO (normally open)
-
It consists of :
o
magnet - separate magnet, placed on the moving part of the shielded opening (door wing)
o
fixed parts - reed switch with a cable, attached to a fixed part of the curtain opening (door frame)
-
The wireless room thermostat that
is included with a particular curtain
is always paired with the curtain.
1.
Weekly programming
2.
Thermostat setting
3.
Thermostat unlocking (hold for 3 sec), mode switching
4.
Increased requirements for temperature:
5.
Decreased requirements for temperature:
6.
ON/OFF thermostat - switches heating on/off
1.
2.
3.
4.
5.
6.
All functions of the wireless room thermostat are described in a
separate manual included in the thermostat package
.
The
wireless thermostat that is included with the curtain is always
paired with the curtain.
Fig. 38
Tab. 10
Fig. 39
