Xinje XG Series, Руководство пользователя

Страница: 70 / 76

62
Appendix 2. Instruction list
All instructions supported by XG series PLC, including basic instructions, application instructions, special
function instructions and motion control instructions, will be listed in Appendix 2, and the range of series
corresponding to these instructions will also be described.
This part is only for the function that users can quickly view instructions. For more detailed application of
instructions, please refer to the user manual of XG series PLC [basic instructions] and [motion control].
Appendix 2-1. Basic instruction list
Mnemonic Function Mnemonic Function
LD Initial logical operation contact type:
NO (normally open)
ORDI Read NC and parallel connection
LDI Initial logical operation contact type:
NC (normally closed)
OUTD Output the point directly
OUT Final logic operation type: coil drive ORB Parallel connection of serial circuit
AND Serial connection of NO ANB Serial connection of parallel circuit
ANI Serial connection of NC MCS New bus line start
OR Parallel connection of NO MCR Bus line return
ORI Parallel connection of NC ALT Alternate coil state
LDP Operation start of pulse rising edge PLS Connect on a scan cycle of pulse rising
edge
LDF Operation start of pulse falling edge PLF Connect on a scan cycle of pulse falling
edge
ANDP Serial connection of pulse rising edge SET Set coil on
ANDF Serial connection of pulse falling edge RST Set coil off
ORP Parallel connection of pulse rising edge OUT Drive counting coil
ORF Parallel connection of pulse rising edge RST Set coil off and current value rest to zero
LDD Read directly from the contact state END I/O process and return to step 0
LDDI Read directly NC GROUP Instruction block fold start
ANDD Read directly from the contact state and
connect serially
GROUPE Instruction block fold end
ANDDI Read NC and connect serially TMR Timing
ORD Read directly from the contact state and
parallel connection