139
3.
When using the FTP protocol, enable the FTP client port.
a.
From the Tools tab screen, select
Connectivity & Network Setup
, then
Port Settings
.
b.
From the Port Settings screen, select
FTP Client
and then select
Change Settings
.
c.
Select
Port Status
and then select
Change Settings
.
d.
Select
Enabled
then select
Save
.
e.
Select
Close
repeatedly until the
Tools tab
screen is displayed.
4.
Set an IP address.
If an IP address is already set, this step is not necessary.
Also, in an environment with DHCP or
BOOTP, configure the way to obtain an IP address. If the address cannot be obtained automatically, or
static configuration is preferred, configure an IP address, a subnet mask, and a gateway address as
follows.
a.
Select
Protocol Settings
.
b.
Select
IPv4 (or other mode) Address Resolution
, then select
Change Settings
.
c.
Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Static], and then select Save. If
you select anything other than [Static], proceed to Step 5.
Note: When communicating by TCP/IP make sure to enable the use of a DNS (or WINS for SMB)
server. This is done using the machine’s Internet Services web pages, displayed by typing the
machine’s IP address into your web browser (as stated in the TCP/IP Dynamic Addressing Topic of
this guide).
d.
On the Protocol Settings screen, select
TCP/IP – IP Address
and then
Change Settings
.
e.
Enter the IP address using the numeric keypad.
Note
Enter the address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in the range
from 0 to 255. However, 224 - 255.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
f.
Select
Save
.
g.
Configure
TCP/IP – Subnet Mask
and
TCP/IP – Gateway Address
using the same process as
stated above.
Notes
Enter the Gateway address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in the
range from 0 to 255. However, 224 - 255.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252, 254, and
255. However, you cannot use 0 between non-zero values.
If you do not set the gateway address, enter "0.0.0.0".
Содержание WorkCentre 7335
Страница 1: ...System Administrator s Guide 701P47693 WorkCentre 7328 7335 7345...
Страница 12: ...x...
Страница 259: ...247 Receive E mail E mail Notification Service Internet Services FTP Client IPP UPnP Discovery WebDAV Bonjour WSD SOAP...
Страница 300: ...701P47693...
