Safety
14
Xerox
®
VersaLink
®
B405 Multifunction Printer
User Guide
Power Cord
Use the power cord supplied with your printer.
•
Plug the power cord directly into a properly grounded electrical outlet. Ensure that each end of the
cord is connected securely. If you do not know if an outlet is grounded, ask an electrician to check
the outlet.
WARNING:
To avoid risk of fire or electrical shock, do not use extension cords, power strips, or
power plugs for more than 90 days. When a permanent outlet receptacle cannot be installed,
use only one factory-assembled extension cord of the appropriate gauge for each printer or
multifunction printer. Always adhere to national and local building, fire, and electrical codes
regarding length of cord, conductor size, grounding, and protection.
•
Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have a
ground connection terminal.
•
Verify that the printer is plugged into an outlet that is providing the correct voltage and power.
Review the electrical specification of the printer with an electrician if necessary.
•
Do not place the printer in an area where people can step on the power cord.
•
Do not place objects on the power cord.
•
If the power cord becomes frayed or worn, replace it.
•
To avoid electrical shock and damage to the cord, grasp the plug when unplugging the power cord.
The power cord is attached to the printer as a plug-in device on the back of the printer. If it is necessary
to disconnect all electrical power from the printer, disconnect the power cord from the electrical outlet.
Emergency Turn Off
If any of the following conditions occur, power off the printer immediately and disconnect the power
cord from the electrical outlet. Contact an authorized Xerox service representative to correct the
problem if:
•
The equipment emits unusual odors or makes unusual noises.
•
The power cable is damaged or frayed.
•
A wall panel circuit breaker, fuse, or other safety device has been tripped.
•
Liquid is spilled into the printer.
•
The printer is exposed to water.
•
Any part of the printer is damaged.
Telephone Line Cord
WARNING:
To reduce the risk of fire, use only No. 26 American Wire Gauge (AWG) or larger
telecommunication line cord.