Xerox Phaser EX7750, Руководство по управлению заданиями

Страница: 127 / 216

6
6-5 Imposition settings
When specifying a sheet size setting, consider the size of the final output. During
imposition, DocBuilder Pro automatically scales pages, if needed, to fit the sheet’s
maximum imageable area. The area does not necessarily extend to the edges of the
sheet. For example, if you perform 1-Up imposition of 8.5
x
11 pages onto 8.5
x
11
sheets, the final pages will be scaled smaller than 8.5 x 11. To retain your original
page sizes, specify a sheet size large enough to accommodate the imposed pages
without scaling.
Creep Adjustment
Choose either Plain or Thick from the Creep Adjustment menu, or enter a value
(between 0 and 2 inches, or the equivalent in another measurement unit) to specify the
thickness of the sheet. When saddle-stitched binding is specified, DocBuilder Pro uses
this value to compensate automatically for binder’s creep (see
“Shingling and creep” on
page A-8).
N
OTE
:
Even if you select Thick from the Creep Adjustment menu, your job is printed
on Plain paper unless you specified Thick paper in the job properties. For more
information about changing job properties from Command WorkStation, see
“Viewing and overriding print settings” on page 3-16.
Orientation
Use the Orientation menu to specify the orientation of a sheet. As an alternative to
rotating the sheet, you can perform custom rotations on any page in the main window,
as described in
“Rotating pages” on page 6-22.
Duplex
Use the Duplex menu to specify the relationship of content areas on opposing sides of
a sheet. Specify On for duplex (two-sided) printing or Off for simplex (one-sided)
printing.
When you choose On, the job is printed as duplex using a Top-Top setting, meaning
that the tops of pages on opposing sides of a sheet are located on the same edge (usually
the preferred choice for imposed book layouts).