Maintenance and Cleaning
Phaser® 6115MFP Multifunction Product
10-3
Keep the following guidelines in mind:
■
Be careful when cleaning the inside of the product or removing media misfeeds, as the
fuser and other internal parts may be very hot.
■
Do not place anything on top of the product.
■
Use a soft cloth to clean the product.
■
Never spray cleaning solutions directly on the product’s surface; the spray could penetrate
through the air vents of the product and damage the internal circuits.
■
Avoid using abrasive or corrosive solutions or solutions that contain solvents (such as
alcohol and benzene) to clean the product.
■
Always test any cleaning solution (such as mild detergent) on a small inconspicuous area
of your product to check the solution’s performance.
■
Never use sharp or rough implements, such as wire or plastic cleaning pads.
■
Always close the product’s covers gently. Never subject the product to vibration.
■
Do not leave the product’s covers open for any length of time, especially in well-lit places.
Light exposure can damage the imaging unit.
■
Do not open the product’s covers during printing.
■
Do not lubricate or disassemble the product.
■
Do not tilt the product while in use.
■
Do not touch the electrical contacts, gears, or laser devices. Doing so may damage the
product and cause the print quality to deteriorate.
■
Keep media in the output bin at a minimum level. If the media is stocked too high, your
product may experience media misfeeds and excessive media curl.
■
Make sure any parts removed during cleaning are replaced before you plug in the product.
