Xerox Phaser 3428, Руководство пользователя

Страница: 19 / 89

2 .6
<System setup>
Network menu (Phaser 3428/DN only)
This menu lets you configure the network interface installed in your
printer. You can reset the network interface and print a configuration
page.
Character
Tab.
This item selects the character set.
Pitch
You can determine the font size by setting the number
of characters that will print in one horizontal inch of
type.
LPI
You can set the number of lines printed in one vertical
inch.
Auto
Wrap
This item determines whether or not the printer
automatically performs line feed when the data
overflows the printable area of the print material.
Item Explanation
TCP/IP
This item allows you to manually set the TCP/IP
addresses or receive the addresses from the
network.
•
DHCP : The DHCP server allots the IP address to
you automatically.
• BOOTP : The BOOTP server allots the IP address
to you automatically.
• Static : You can enter IP address, subnet mask,
and gateway manually.
EtherTalk
This item lets you select whether or not you use the
EtherTalk protocol.
Item Explanation
Values: ITALIC, PC437US, PC850
Values: 10, 12, 17.14, 20
Values: 6, 8
Values: Off, On
Values: DHCP, BOOTP, Static
Values: Off, On
Printing a demo page
Print a demo page to make sure that the printer is operating correctly.
1 Press Menu and then OK when Information appears.
2 Press the Scroll buttons until Demo Page appears and press OK .
A demo page prints out.
Changing the display language
To change the language that is displayed on the control panel, follow
these steps:
1 Press Menu until System Setup appears on the bottom line of the
display and press OK .
2 Press OK when Language appears.
3 Press the Scroll buttons to select the language you want and press
OK .
4 Press Stop to return to Standby mode.
NetWare
This item lets you select the IPX frame type.
•
Auto : You can set the frame type automatically.
• 802.2 : Select this value to use the IEEE 802.2
frame type.
• 802.3 : Select this value to use the IEEE 802.3
frame type.
• Ethernet II : Select this value to use the Ethernet 2
frame type.
• SNAP : Select this value to use the SNAP frame
type.
• Off : You can disable the NetWare protocol.
Ethernet
Speed
This item allows you to select the ethernet speed.
Clear
Setting This item performs a simple reset and restores the
factory default settings for the network
configuration. This setting will only take effect after
you have reset the printer.
Network
Info. This item print a page showing the network
parameters you set.
Item Explanation
Values: Auto, 802.2, 802.3, Ethernet II, SNAP, Off
Values: Auto, 10M Half, 10M Full,
100M Half, 100M Full