Xerox DocuPrint C55, Дополнительное руководство

Страница: 227 / 395

C E N T R E W A R E D P S O F T W A R E I N S T R U C T I O N S 24
SERIAL TAB
This screen enables the use of check boxes to select or change serial port
options as follows:
Enable
Port Printer is ready to print directly from the printer’s serial port
using a PC or UNIX workstation.
Mode There are three modes which you can choose manually for the
serial port, or choose Auto Select:
PostScript - The printer accepts PostScript without binary
data. Use of this mode requires all binary information to be
encoded in ASCII.
PostScript TBCP (Tagged Binary Communications Protocol)
Mode - This mode uses special control characters to enter and
exit the binary mode, within a PostScript job. This mode is the
factory default.
PostScript Binary - This mode allows the sending of binary
data within a PostScript job.
Baud
Rate This selection must match the baud rate set at your
workstation’s serial port. The factory default is 9600.
Parity This selection, when enabled, allows for error checking of the
data that is being transferred. The factory default is None,
which means disabled.
Stop Bits This selection defines the number of bits used for the end of a
character cell. The factory default is 1.
Data
Bits This selection defines the number of bits used to construct a
character. The factory default is 8.
Flow
Control This selection provides a means to start and stop data flow.
The following two selections are available:
DTR: A control line in the serial cable is used to start and stop
data flow.
XON/XOFF: A control character is imbedded in the data
stream to start and stop data flow. This is the factory default.