Xerox DocuPrint 4517, Руководство пользователя

Страница: 109 / 288

C o n t r o l P a n e l M e s s a g e s
C h a p t e r 6 : T r o u b l e s h o o t i n g
❖
6-9
Disk Format Bad
The hard disk high level format (FAT table) cannot be understood. This is NOT
because a new disk has been installed.
ACTION: Either initialize the disk format procedure by pressing Up , or abort
the procedure by pressing Down .
This message flashes alternately with the two-line message:
Press
↑
to Init
Press
↓
to Abort
Disk Not In Use
A failure of the hard disk has occurred and been acknowledged. Printing resumes
without use of the hard disk.
ACTION: Make sure the hard disk is properly seated on the controller board. If
the problem remains, contact your dealer or Xerox/Rank Xerox.
Disk Read Error
The printer cannot read data from the hard disk.
ACTION: Try powering the printer OFF then ON again. Make sure the hard disk
is properly seated on the controller board. If the problem remains,
contact your dealer or Xerox/Rank Xerox.
Disk Write Error
The printer cannot write data to the hard disk.
ACTION: Press Enter . The printer will mark the disk sector as bad and retry
the write operation at another location on the disk. Make sure the
hard disk is properly seated on the controller board. If the problem
remains, contact your dealer or Xerox/Rank Xerox.
Duplex Unit Fail
The Duplex Module has failed. Duplex (two-sided) printing cannot continue. You
can, however, still print simplex (single-sided) prints.
ACTION: Remove and reinstall the Duplex Module following the instructions in
Appendix C: Installing and Removing Printer Options . If it still fails,
contact your dealer or Xerox/Rank Xerox.
Enter Password
>> xxxx
The bin unlock button has been pressed on the Mailbox/Collator and a password
has been enabled.
ACTION: Enter the password for the bin or collator that you wish to open.
This message can also occur while enabling or disabling a password for a bin or
the collator.
ACTION: Enter the password used last time that bin or collator had its password
enabled (or the factory default password the first time). Then you will
be allowed to proceed with enabling or disabling the password.
Table 6.2 Control Panel messages (continued)
Message
Description/Corrective Action
Table 6.2 Page 4 of 22
chapter6.frm Page 9 Friday, July 11, 1997 8:19 PM