Xerox DocuPrint 4050 NPS, Руководство по эксплуатации

Страница: 83 / 248

PRINTER CONTROLLER MESSAGES
XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE 48-19
E280 Incorrect developer
housing present. Printer type (50 ppm vs. 92 ppm) and color developer
housing type do not match.
1. Open the front left door.
2. Remove the incorrect color developer housing.
3. Install the correct color developer housing.
4. Close the left front door.
E305 Replace developer waste
container (full or not
present). The developer waste container is full or not present.
1. Open the front left door.
2. Replace the container.
3. Close the left front door.
E308 Toner waste container
not present. The toner waste container is not present.
1. Open the toner waste container access door (rear
door).
2. Insert a toner waste container.
3. Close the toner waste container access door (rear
door).
4. Press the Continue button.
E309 Toner waste container
full. The toner waste near full sensor has been activated and
more than 1000 pitches have occurred.
1. Open the toner waste container access door (rear
door).
2. Remove the full toner waste container.
3. Insert an empty toner waste container.
4. Close the toner waste container access door (rear
door).
5. Press the Continue button.
E315 Low black toner detected
by toner sensor. Black dry ink is too low.
Add black dry ink toner.
E316 Low color toner detected
by toner sensor. Color dry ink is too low.
Add color dry ink toner.
F004 CDM lost machine clock. There is a machine clock sensor problem, a CDM board
failure, or a harness problem between the machine clock
sensor and CDM.
1. Discard purged output.
2. Press the Continue button.
3. If problem persists, notify your service representative.
F005 MIR lost machine clock. The failure may be caused by a CPM or MIR board failure
or a harness problem between CPM and MIR.
Message Explanation/action