Xerox DocuPrint 4050 NPS, Руководство по эксплуатации

Страница: 56 / 248

PRINTER CONTROLLER MESSAGES
48-36 XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE
J247 Transfer assist blade
disengage failure. The transfer assist blade function failed to initialize
because solenoids did not disengage while level two is
NVM enabled.
No action required.
If problem persists, notify your service representative.
J261 XAN realtime clock
failure. A XAN realtime clock failure has occurred.
No action required.
If problem persists, notify your service representative.
J322 TAC sensor dirty. The TAC sensor is dirty.
No action required.
If problem persists, notify your service representative.
J334 Patch generator intensity
at maximum. A patch generator error has been detected.
No action required.
If problem persists, notify your service representative.
J342 CAD loss at limit. A CAD loss failure has occurred.
No action required.
If problem persists, notify your service representative.
J343 Charge shield voltage at
maximum. A charge shield failure has occurred.
No action required.
If problem persists, notify your service representative.
J349 Cycle 1-2 measurement
greater than 12 bits. A PQA failure has occurred.
No action required.
If problem persists, notify your service representative.
L020 FOR or BFR failed
memory/communication. FOR or BFR failed memory communication. Prints can be
made to the top tray. This message displays only if the
stacker is selected.
1. Deselect output.
2. Press the Continue button.
L034 Fuser fallen below preset
temperature. The fuser is too cool.
1. Wait for the message to clear automatically, and
press the Continue button.
2. If problem persists, notify your service representative.
L035 IOT in power saver mode. The printer has been idle beyond the preset time.
Press Continue button if the printer is needed, or send a
job and allow for warm-up time.
L044 Top tray capacity
reached. About 100 sheets have been sent to the processor top
tray.
Remove paper from the tray.
Message Explanation/action