Xerox Document centre 250 series, Руководство пользователя

Страница: 124 / 185

112
7
7.1 When Problems Occur
Printing has been
specified but the
Print Processing
LED does not light
up.
Printing
specification has
been sent to the
bypass tray but no
printing is done.
No printing is sent
but display shows
"Printing".
Turn the switch off and check the
interface cable connection.
Turn the printer power switch off
and check the installation status of
the interface card.
Check the port status of the
interface.
"5.3 Common Menu Items"
Check the operating environment
of the host device such as the
printer driver.
Turn the power switch off and
install the additional RAM module
to increase the memory.
Insert in the correct size paper and
send printing again.
User Guide (Copier)
Just wait for five minutes or press
and together to stop
printing.
Condition Cause Treatment
If the memory is insufficient,
the printer will automatically
inactivate the interface and
then activate itself again.
When switching on the power
of the printer, check whether
the host device is switched on.
Is the interface cable securely
connected?
If the interface card is used, has
it been correctly set?
Is the interface card activated?
Is the operating environment of
the host device correctly set?
Is the memory sufficient?
Are the specified paper size
being used?
Is the power of the host device
turned on after the printer has
been on?