Front Panel
TM-XDOP-01XN
1–5
Figure 1-3
Keypad
Table 1-3
Item Descriptions for Figure 1-3
Item
Description
1
Voltage knob:
Turn knob to increase or decrease output voltage.
(This is a velocity- sensitive rotary encoder.)
2
Current knob:
Turn knob to increase or decrease output current
limit. (This is a velocity-sensitive rotary encoder.) The secondary
functions for keys 3-5 listed below operate when the power supply
is in Auto Sequence.
3
VOLTAGE set key:
View and set voltage output setpoint.
RUN/PAUSE Auto Sequence Program:
Start a selected program
or pause the program.
4
CURRENT set key:
View and set current output setpoint.
TRIGGER for Auto Sequence Program:
Apply a trigger when
requested. This key may also be used to advance to the next step
in the program by pressing and holding.
5
STORE settings key:
Save power supply output settings to one of
ten locations.
END Auto Sequence Programming:
Stop the program. The
program will start from the beginning when RUN is pressed.
6
OUT ON/OFF key:
Toggle between Output ON and Output OFF.
7
LCL/RMT key:
Toggle between local mode and remote mode (or
Go to Local for GPIB operation) except during calibration.
8
PROTECTION SET key:
View and set protection setpoints.
ALARM response:
Read and clear alarm messages. ALARM
annunciator indicates if there are any alarm messages.
1
2
3
4
5
6
7
8
9
10
11
12
13
16
17
14
15
TM-XDOP-01XN.book Page 5 Monday, July 17, 2006 11:19 AM
Содержание XDC 10-1200
