Xantrex GT2.8-AU-QC-230, Руководство пользователя

Страница: 38 / 90

Installation
2–16 975-0466-01-01
Mounting the Inverter on the Bracket
Before mounting the inverter, remove the communication ports cover (if it has
been attached to the unit). With the cover removed, you can access all the
mounting slots along the bottom flange. Ensure the communication ports cover is
installed after mounting and wiring are completed.
Mounting a Single Inverter
To mount the inverter on the mounting bracket:
1. Place the GT Inverter’s mounting hook, located on the back of the enclosure,
over the bracket and ensure the inverter is seated properly, as shown in
Figure 2-8.
2. After the unit is correctly seated on the bracket hook, locate the mounting
slots at the bottom of the unit, and mark the location on the wall for securing
screws.
3. Remove the inverter and drill pilot holes in the wallboard, brick or concrete
for the securing screws.
4. Reinstall the GT Inverter on the bracket and secure the bottom of the unit with
appropriate screws or anchors, and tighten.
Figure 2-8 Proper Placement of the Inverter on the Mounting Bracket
Slide the mounting hooks on the inverter
over the hooks on the mounting bracket. Ensure the inverter is
seated properly on the
mounting bracket
Flange with
mounting slots
130 cm 100 cm