Xantrex GT2.8-AU-QC-230, Руководство пользователя

Страница: 61 / 90

Front Panel Display Screens and What They Mean
975-0466-01-01 5–3
Front Panel Display Screens and What They Mean
The front panel display shows different message screens during different modes of
operation (Startup, Normal, Offline, and Fault). All single units display a basic set
of message screens; multiple unit systems display additional screens in Normal
Operation and Offline modes.
In addition there are special message screens that may appear in any operational
mode. All of these message screens are described in more detail in the following
tables.
Startup Mode
During startup, the GT Inverter displays several message screens on its front panel
LCD. The startup screens appear in the order shown in Table 5-1.
Important:
For the tables in this section, all numbers are examples only. Your model,
revision numbers, and performance data will vary.
Table 5-1 Startup Screens on GT5.0-AU Front Panel Display
Display* Duration Description
Power 5000W
AU-230V
5 seconds Startup message 1: Maximum output power and
Region-nominal output voltage
Flash = 03.01
.. ROM = 03.00
5 seconds Startup message 2: Model and revision numbers
for Flash and ROM memory on the GT Inverter.
The ROM revision number applies to the
protection processor.
Vh= 253V
Clr t < 0.20s
3 seconds Vh: high threshold voltage setting, the threshold at
which the inverter disconnects itself from the
power grid when abnormally high AC voltage is
detected.†
Clr t: clear time.‡
Vl= 196V
Clr t < 0.20s
3 seconds Vl: low threshold voltage setting, the threshold at
which the inverter disconnects itself from the
power grid when abnormally low AC voltage is
detected.
Clr t: clear time.
Vph= 0V
Clr t < 0.20s
3 seconds Vph: phase-to-neutral (rms) high threshold
voltage setting. Note : Phase-to-neutral threshold
voltages are disabled for Australian GT Inverter
models so this screen always displays
0V .
Clr t: clear time.