Xantrex GT2.8-AU-QC-230, Руководство пользователя

Страница: 51 / 90

Communications Wiring for Multiple Inverters
975-0466-01-01 3–13
Network cables The network uses Category 5 (CAT 5 or CAT 5e) cable, a standard Ethernet cable
available from any computer supply store.
Purchasing Network Components
Consult your system designer to determine what network components will be
needed for your specific installation. Table 3-3 provides a partial list of network
components and part numbers. Pre-made cables are available in lengths from 0.9
to 22.9 metres.
Call your dealer or visit www.xantrex.com for information on purchasing
network components.
Guidelines for Routing the Network Cables
To ensure maximum performance of your network, follow these guidelines when
routing the network cables. Route the cables before installing Xanbus-enabled
devices.
• Route the cables away from sharp edges that might damage the insulation.
Avoid sharp bends in the cable—no less than a 100 mm radius.
• Allow for some slack in the cable.
• Keep the alignment of wire pairs inside the sheath as straight as possible.
CAUTION: Equipment damage
Do not use crossover cable in a Xanbus system.
Figure 3-11 Network Cable
Table 3-3 Network Components and Part Numbers
Network Component Part Number
Network cable 0.9 m 809-0935
Network cable 7.6 m 809-0940
Network cable 22.9 m 809-0942
:
WARNING: Shock hazard
Do not route the network cables in the same conduit or panel as the AC and DC power
cabling.