Xantrex GPIB-M-HPD, Руководство по эксплуатации

Страница: 65 / 134

Operation
Auto Sequencing
Release 2.1
63
Querying the number of steps
To query the number of steps that have been programmed:
PROGram:STEP:COUNt?
Deleting a
Sequence
Deleting Sequences
If you no longer need a sequence, select it with the
PROG:NAME
command and then
delete it with the following:
PROGram:DELete
You can also use the following to delete all sequences:
PROGram:DELete:ALL
Using Auto
Sequencing
Auto Sequence programs can be set to run as a Power ON default or recalled from
memory.
Auto sequence programs can operate 3 different ways:
•
They can run automatically through a series of steps, repeating those steps a
pre-set number of times if necessary, and complete their operation without
intervention from an operator.
•
They can run automatically and be paused. If you need to stop the program
temporarily, change its state to “ PAUSE ” to stop it, and then change the
program’s state to “ RUN ” to resume the program’s operation when ready. The
output remains on and voltage may be present at the output.
•
They can run automatically programmed to wait for a trigger at certain points in
the sequence. If you want the program to resume, you can supply a trigger signal
to the rear panel Trigger input.
Select Sequence to Run
To run an auto sequence program, first select the program you wish to run:
PROGram:NAME <sequence_number>
where <sequence_number>
can range from 1 to 10.