WYTRON CD-398, Руководство по эксплуатации

Страница: 19 / 58

19
e.
When Copy is completed on all writers, those discs
passed will be ejected automatically (default setting:
Passed discs will be ejected but this can be changed
according to your need). For continuous duplication,
place additional blank discs into the writers and repeat
the above procedures.
f. Failed disc(s) will remain in respective writer(s) (Default
setting: Failed discs will NOT be ejected but this can be
changed according to your need). Press MODE switch
will eject those failed discs from writers or press each
eject button on the writer to eject disc manually.
g. The duplicator will prompt you an error message when
you try to copy a partition that contains no data. In this
case, switch to “Load” function to load data first.
h. Do not press any switch during operation as interruption /
termination of operation will cause error and might cause
the duplicator to hang up (depend on writers installed).
The write-once discs during operation will be ruined and
might not be used again.
BB. Without hard drive
a. Switch to Copy by pressing MODE switch. Put blank discs
into all writers and duplicator will start copying when all
writers detect the discs. If you do not need to use all
writers for copying, the LCD display will display the
number of disc detected as “ Xstart” (X represents the
number of writer with detected discs that are ready to
copy). Press the GO switch and operation will start
instantly. There is no imitation on number of disc to be
copied in one round (Vary on different model, CD-398 /
DVD-399 will be 9 pcs. in maximum targets. For DVD-299
controller card, there will be three targets in maximum.
For CD-129 and DVD-299 one to one duplicator, there is