5-36
Basic Configuration
•
Logoff Character:
Defines the Logoff Character for this port. This determines
which command(s) must be issued at this port in order to disconnect from a second
port. (Default =
^X
(
[Ctrl]
plus
[X]
).)
Note:
The Sequence Disconnect parameter can be used to pick a one
character or a three character logoff sequence.
•
Sequence Disconnect:
Enables/Disables and configures the Resident Disconnect
command. Offers the option to either disable the Sequence Disconnect, or select a
one character, or three character command format. (Default = One Character).
Notes:
• The One Character Disconnect is intended for situations where the
destination port should
not
receive the disconnect command. When the
Three Character format is selected, the disconnect sequence
will
pass
through to the destination port prior to breaking the connection.
• When Three Character format is selected, the Resident Disconnect uses the
format "
[Enter]
LLL
[Enter]
", where
L
is the selected Logoff Character.
•
Inactivity Timeout:
Enables and selects the Inactivity Timeout period for the
Network Port. If enabled, and the port does not receive or transmit data for the
specified time period, the port will disconnect. (Default = 5 Minutes).
•
Command Echo:
Enables or Disables the command echo for the Network Port.
(Default = On).
•
Accept Break:
Determines whether the port will accept breaks received from the
attached device, and pass them along to a connected port. When enabled, breaks
received at this port will be passed to any port this port is connected to, and sent
to the device connected to the other port. When disabled, breaks will be refused at
this port. (Default = On.)
•
Multiple Logins:
(Text Interface Only) If the RSM-8R is installed in an environment
that
does not
include communication via an open network (local communication
only), then the Multiple Logins parameter can be used to determine whether or not
multiple users will be able to communicate with the unit at the same time. If this
parameter is set to "Off" then only one user will be allowed to communicate with the
unit at a time. (Default = On.)