wsm wg972-e4, Руководство по ремонту

Страница: 42 / 153

GENERAL
WG972-E4, WSM
G-16
[4] CHECK POINTS OF EVERY 100 HOURS
Cleaning Spark Plug (If Necessary)
1. Remove the spark plug, and remove carbon from the electrode
with a wire brush or other tools.
2. After cleaning, be sure to adjust for proper clearance.
IMPORTANT
• If the spark plug electrode or its insulator is soiled or is
covered with deposited carbon, it may cause engine
trouble.
9Y1211108GEG0027US0
Adjusting Spark Plug (If Necessary)
1. Measure the spark plug gap with a feeler gauge, and repair or
replace the spark plug if the measured gap differs from the
factory specification.
2. Replace the spark plug if the electrode or the insulator is
deformed or cracked.
3. Tighten the spark plug with a plug wrench.
IMPORTANT
• If the spark plug electrode or its insulator is soiled or is
covered with deposited carbon, it may cause engine
trouble.
(When reassembling)
• Put the high tension cord cap inside the spark plug terminal
firmly.
• Make sure that the cylinder number is corresponding to the high
tension cord number.
• Wrong connection causes high temperature on catalytic
muffler/converter.
9Y1211108GEG0057US0
Checking Fuel Filter (Gasoline Line) [WG972-GL, WG972-G]
1. Check the fuel filter with visual check.
2. If the fuel filter is dirty, replace it.
CAUTION
• Stop the engine when trying to check and clean the fuel
filter.
• Gasoline fuel is extremely flammable, so avoid fires.
9Y1211108GEG0028US0
Spark plug gap Factory specification
0.70 to 0.80 mm
0.029 to 0.032 in.
Spark plug NGK BKR6E
Tightening torque Spark plug
24.5 to 29.4 N·m
2.50 to 2.99 kgf·m
18.1 to 21.6 lbf·ft
(1) Gasoline Fuel Filter
(2) Fuel Hose (3) Clamp
KiSC issued 07, 2015 A